Crystalyne

Sailboat Racing Rope

HOW TO BUY  

Crystalyne

Crystalyne is a double-braided rope constructed with an inner load-bearing core of Vectran Liquid Crystal Polymer (LCP) and has a tough polyester outer sleeve. LCP is more tolerant of bending than other high-modulus fibers and is not as affected by overloading.

Crystalyne exhibits more tension cycles to higher percentages of break than all our other high-modulus offerings. Unlike ultra-high-molecular-weight polyethylene (UHMPE) ropes, LCP fiber has little or no tendency to creep and can be used to hold tight tolerances in rope assemblies.

Vectran is hydrophobic, meaning it cannot absorb water. This rope is spliced using the same technique as our Maxibraid Plus, resulting in a termination that finishes shorter than conventional splice techniques and remains supple.

Crystalyne Specifications and Data

Diameter (Inches) Average Spliced Break Strength *(Lbs) Minimum Spliced Break Strength *(Lbs) Maximum Work Load 5:1 **(Lbs) Weight (Lbs/100f)
3/16 3,000 2,700 600 1.4
1/4 5,000 4,500 1,000 2.2
5/16 7,200 6,480 1,440 3.0
3/8 11,500 10,350 2,300 4.4
7/16 15,200 13,680 3,040 6.1
1/2 20,000 18,000 4,000 8.5
9/16 26,000 23,400 5,200 11.1
5/8 30,000 27,000 6,000 12.0
11/16 40,000 36,000 8,000 18.8
3/4 45,000 40,500 9,000 20.0
7/8 63,000 56,700 12,600 24.4
1 80,000 72,000 16,000 33.3
1-1/8 100,000 90,000 20,000 41.6
1-1/4 120,000 108,000 24,000 46.0


* Knots and abrupt bends significantly reduce the strength of all ropes and lower the maximum working load.
** Working load is based on static or moderately dynamic lifting/pulling operations. Instantaneous changes in load, up or down, in excess of 10% of the rope’s rated working load constitute hazardous shock load and would void the normal working-load recommendation. Consult Yale Cordage for guidelines for working loads and the safe use of rope.

 

Green working 187 ft. lbs./lb.
Red ultimate 3,403 ft. lbs./lb.

Specific Gravity: 1.40

Dielectric Strength: Crystalyne’s core of LCP is hydrophobic, so its lack of core moisture gain is an advantage, as is its high melt point of 620°F (325°C). The polyester sleeve governs the leakage, which is 100 micro-amperes at 100kV per Yale Method 712-1701 Rev 1 "Routine Production Test."


Maximum Working Load
Minimum Break Strength
Average Break Strength

Crystalyne Splicing Instructions

Approved Splice Technique: #10015110, #10018007.