Vectrus is a single-braid rope of 100% Vectran™ LCP (Liquid Crystal Polymer) and is always treated with Yale’s Maxijacket coating to increase abrasion resistance and enhance the fibers' UV resistance. LCP is more tolerant of tighter bending radii in terminations than other high-modulus fibers.
Vectran LCP thrives at high loads and will sustain repeated loads more times than other high-strength, low-stretch fibers. LCP has no tendency to creep, making it a perfect solution for some critical applications where little or no dimensional tolerance is acceptable. In fact, Vectrus was one of the products selected to suspend the 40-ft.-diameter acrylic vessel filled with $225 million of heavy water at the Sudbury Neutrino Observatory (sno.phy.queensu.ca) and has been in service over 10 years, without movement. The 620°F (325°C) melt point also allows this rope to be used in heat applications formerly left only to wire rope.
Our line of synthetic mining lifelines and carrier wires are better alternative to traditional wire cable, being stronger, safer and lighter.
Vectrus has outstanding sunlight resistance and no moisture weight gain-at a fraction of the weight of wire.
We test our sailboat racing ropes both in our labs and at sea, where reliable performance can define the difference between victory — and everything else.
|Diameter (Inches)||Average Spliced Break Strength *(Lbs)||Minimum Spliced Break Strength *(Lbs)||Maximum Working Load 5:1 **(Lbs)||Weight (Lbs/100f)|
* Knots and abrupt bends significantly reduce the strength of all ropes and lower the maximum working load.
** Working load is based on static or moderately dynamic lifting/pulling operations. Instantaneous changes in load, up or down, in excess of 10% of the rope’s rated working load constitute hazardous shock load and would void the normal working-load recommendation. Consult Yale Cordage for guidelines for working loads and the safe use of rope.
Green working 232 ft. lbs./lb.
Red ultimate 4,446 ft. lbs./lb.
Specific Gravity: 1.40
Dielectric Strength: The maximum allowable leakage for clean, dry Vectrus is 100 micro-amperes when tested at 100kV per Yale Method 712-1701 Rev 1 "Routine Production Test". Absorbed and entrained moisture or impurities will increase rope’s conductivity dramatically.
Approved Splice Technique: #10015109, #10018009.